الاثنين، 26 مايو 2014

Elevator Installers and Repairers - Yida Elevator Saudi Arabia

Assemble, install, repair, or maintain electric freight or passenger elevators



Job Tasks



-Assemble, install, repair, and maintain elevators, using hand and power tools, and testing devices such as test lamps, ammeters, and voltmeters.



-Test newly installed equipment to ensure that it meets specifications, such as stopping at floors for set amounts of time.



-Locate malfunctions in brakes, motors, switches, and signal and control systems, using test equipment.



-Check that safety regulations and building codes are met, and complete service reports verifying conformance to standards.



-Connect electrical wiring to control panels and electric motors.



-Adjust safety controls, counterweights, door mechanisms, and components such as valves, ratchets, seals, and brake linings.



-Read and interpret blueprints to determine the layout of system components, frameworks, and foundations, and to select installation equipment.



-Inspect wiring connections, control panel hookups, door installations, and alignments and clearances of cars and hoistways to ensure that equipment will operate properly.



-Disassemble defective units, and repair or replace parts such as locks, gears, cables, and electric wiring.



-Maintain log books that detail all repairs and checks performed.



-Participate in additional training to keep skills up-to-date.



-Attach guide shoes and rollers to minimize the lateral motion of cars as they travel through shafts.



-Operate elevators to determine power demands, and test power consumption to detect overload factors.



-Connect car frames to counterweights, using steel cables.



-Bolt or weld steel rails to the walls of shafts to guide elevators, working from scaffolding or platforms.



-Assemble elevator cars, installing each car's platform, walls, and doors.



-Install outer doors and door frames at elevator entrances on each floor of a structure.



-Install electrical wires and controls by attaching conduit along shaft walls from floor to floor, then pulling plastic-covered wires through the conduit..



-Cut prefabricated sections of framework, rails, and other components to specified dimensions.


تفاصيل الوظيفة


























2014-05-21تاريخ الإعلان عنها:
جدة, المملكة العربية السعوديةمنطقة الوظيفة:
الهندسةالدور الوظيفي:
بناء وتشييدقطاع الشركة:
2014-06-01تاريخ الالتحاق بالعمل:


المرشح المفضل














متوسط الخبرةالمستوى المهني:
ذكرالجنس:


تقدم الآن - وظائف في السعودية - وظائف في جدة, المملكة العربية السعودية - وظائف في الرياض, المملكة العربية السعودية - وظائف الهندسة في السعودية - بحث عن جميع الوظائف






http://ift.tt/1ms8KK5